google-site-verification=7DlVmmd_ndItiIG67eXUCsY1LYTobXGDajfNbLfbOqo

weld on steel pipe caps


Date:

2023-05-31

Cap: Fitted at the end of a pipe, welded or threaded, usually ellipsoidal. The straight pipe section is longer than the head. It is generally used for pipelines with relatively high pressure of small diameter.

Cap: Fitted at the end of a pipe, welded or threaded, usually ellipsoidal. The straight pipe section is longer than the head. It is generally used for pipelines with relatively high pressure of small diameter. Head: The end, usually round or tapered, at which pipes or pressure vessels are installed. Caps are generally used for the end of the pipe, and the head is used for the upper and lower parts of the container equipment (vertical equipment) or the left and right ends (horizontal equipment). Caps are generally OD sizes, such as 219,273,325, etc. The pipe cap is also called the plug, cover, pipe cap, bulkhead, installed on the pipe end of the external thread to cover the pipe fittings. Used to close the pipeline, the role is the same as the pipe plug, but the pipe cap can be directly screwed on the pipe, do not need other pipe fittings. Generally, it is used at the sampling port without the end of the pipe. After the sampling is completed, the pipe cap should be screwed on. In special cases, after the cap is screwed off, the pipe can be connected to the wire port for temporary continuous material taking or pumping. With the tube cap generally in the case of low pressure, easy to disassemble and repair, high pressure in general do not need to tube cap.

Key Words:

Fitted,pipe